We recommend using The Tankless EZ-Flush Flow-Aide System Descaler Kit to ensure a Clean, Energy-Efficient, Long Lasting Heater!
The Flow-Aide System Descaler Is NSF Approved & Safe To Dispose Of In Drains.
Also Recommended For : Ice Machines, Humidifiers, Water Heaters, Boilers, Heat Exchangers, Chillers, Vacuum Pumps, Condensers, Evaporators, Tanks Portable Waterlines, Water Operated Equipments …
It Includes The following Pieces :
(1) ___ 3.5 Gallon Bucket
(1) ___ 500 GPH Pump
(2) ___ 5 Foot Rubber Hoses
(1) ___ Quart Flow-Aide
#1 ► Disconnect Power To Water Heater.
#2 ► Close Hot, Cold Isolation and Service Valves. Remove Service Caps.
#3 ► Pour 1.25 Gallons Of Water Into Bucket and Place Under Water Heater.
#4 ► Add Contents Of 1 Quart Bottle Of Whitlam Flow-Aide Into Bucket. Bucket should be 1/2 Full.
The Higher The Concentration The Faster The System Will Be Cleaned.
Minimum Dilutions Is 1 Part Water To 1 Part Flow-Aide.
Be Sure To Have Enough Solution To Keep The Pump Submersed When In Use.
#5 ► Connect One Hose To Pump & Other End Of Same Hose To Cold Service Valve. Place Pump In Bucket.
#6 ► Connect Second Hose To Hot Service Valve. Place Other End In Bucket.
#7 ► Open Both Hot & Cold Service Valves.
#8 ► Plug Pump Into Grounded Receptacle.
#9 ► Allow Pump To Circulate Whitlam Flow-Aide Solution Via Heater For 30-45 Min. Unplug Pump.
#10 ► Close Cold Service Valve.Remove Hose From Cold Service Valve.Replace Service Cap.
#11 ► Disconnect The Hose From The Pump And Remove Pump From Bucket. Discard Flow-Aide Solution.
#12 ► Flush Tankless Water Heater For 3-5 Minutes Or Until Water Flows Clear By Opening The Cold Isolation Valve and Allowing Water To Exit Through The Hot Service Valve Into A Drain Or Bucket.
If Using A Bucket, Empty Periodically.
#13 ► Close Hot Service Valve. Remove Hose From Service Valve. Replace Service Cap.
#14 ► Open Hot Isolation Valve.
#15 ► Connect Power To Water Heater and Return Appliance To Service.